RW 1224


LOW TEMPERATURE QUICK SETTING
POLYESTER CONCRETE PATCHING COMPOUND


RW 1224 is a flexible resin with high compressive strength, chemical resistant, low shrinkage, bonds well and will not crack. RW 1224 will set up on damp surfaces. It will set up in temperatures below 0 degrees. It will set up in ambient temperatures in under 10 minutes, and one half hour after it hardens you can walk on it. 1 hour after it hardens, you can drive a fork lift over it. You can fill holes or cracks in a concrete floor or wall. You can rebuild a chipped concrete step or curb.

It has been our experience that dangerous holes in concrete were not repaired in high traffic areas because of long cure times in epoxy patches. You can address a potential slip fall hazard immediately with RW 1224 because of the quick cure time.


TEST RESULTS

Prepare one 1/4" flat casting and one 1" square bar

Composition: 2.5 parts aggregate with 1 part resin, gelled and cured at room temperature only.

Barcol Hardness 45-55
D-790
Flexural St. psi. 2,275
Flexural St. St. Dev. 85
Flexural Mod. psix10-5 3.32
Flexural Mod. St. Dev. 0.16
D-695
Compressive St. psi 5,933
Compressive St. St. Dev. 128
Compressive Mod psix10-5 2.25
Compressive Mod St. Dev. 0.17



arkalabs1@aol.com